Drawing with the Circle tool TTR

Click the Circle tool and the first prompt enter t (the abbreviation for the prompt tan tan radius), followed by a right-click.

Command:_circle Specify center point for circle or [3P/2P/Ttr (tan tan radius)]: enter right-click

Specify point on object for first tangent of circle: pick

Specify point on object for second tangent of circle: pick

Specify radius of circle (40): enter 30 right-click

Command: c

CIRCLE Specify center point for circle or [3P/2P/Ttr (tan tan radius)]:

Specify radius of circle or [Diameter]:

Requires numeric radius, point on circumference, or "D".

Specify radius of circle or [Diameter]: 40

Command:

CIRCLE Specify center point for circle or [3P/2P/Ttr (tan tan radius)]:

Specify radius of circle or [Diameter] <40.0000>:

Requires numeric radius, point on circumference, or "D".

Specify radius of circle or [Diameter] <40.0000>: 40

Command: c

CIRCLE Specify center point for circle or [3P/2P/Ttr (tan tan radius)]: ttr

Specify point on object for first tangent of circle:

Specify point on object for second tangent of circle:

Specify radius of circle <40.0000>: 30

Command:

Command:

Command: _dimradius

Select arc or circle:

Dimension text = 30

Specify dimension line location or [Mtext/Text/Angle]:

Command:

DIMRADIUS

Select arc or circle:

Dimension text = 40

Specify dimension line location or [Mtext/Text/Angle]:

Command:

DIMRADIUS

Select arc or circle:

Dimension text = 40

Specify dimension line location or [Mtext/Text/Angle]:

Command:

The radius 30 circle, tangential to the two already drawn circles, then appears

When a point on either circle is picked a tip appears Deferred Tangent.

This tip will appear only when the OSNAP is set on with a click on the button, or the F3 key of the keyboard is pressed.

Circles can be drawn through 3 points or through 2 points entered at the command line in response to prompts brought to the command line by using 3P and 2P in answer to the circle command line prompts.

Read more........

Berbagi :