modifications hatch AUTOCAD
We can also modify the solid-filled areas, but the method we use depends on whether the solid filled area filled with dense hatch,
2D solid, or polyline width or donuts. We can also modify the order of hatching We draw from.
Hatch Pattern density control
Hatching can produce a very large number of objects lines and points. Although the hatch is stored as an object, the objects using lines and dots of disk space and time to generate. If we use the scale factor is relatively small when hatched a particular area, hatch could require millions of lines and object points, thus taking a very long time to complete and may be exhausting the resources available. We can avoid this problem by implementing a limit on the number of objects created by a single or a command BHATCH Hatch. If the estimated number of objects needed for a particular hatch (consider the boundary area, patterns, and scales) to exceed the limits, AutoCAD displays a message indicating that the hatch scale is too small or that the length of the line is too short, and the hold request was rejected. If this happens, carefully check the settings we hatch. Scale factor that may not make sense and may need to be adjusted.
We can modify the pattern properties, such as the scale and angle of the hatch, the hatch is, or we can choose a new pattern to it.
We can also explode hatch pattern into component objects.
To change the angle of a hatch
Select the hatch pattern.
Right-click the hatch and click Properties on the shortcut menu.
In the Properties palette, enter the new value for Angle.
